Users Guide
Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
7.7.1.0 Introduced on the E-Series.
Related Commands
• ip redirect-list – enable an IP Redirect List.
ip redirect-group
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an interface by entering this command
multiple times.
Syntax
ip redirect-group redirect-list-name
To remove a redirect list from an interface, use the no ip redirect-group name command.
Parameters
redirect-list-name Enter the name of a congured redirect list.
Defaults None
Command Modes INTERFACE (conf-if-vl-)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
7.7.1.0 Introduced on the E-Series.
Usage Information
You can apply any number of redirect-groups to an interface. A redirect list can contain any number of congured
rules. These rules includes the next-hop IP address where the incoming trac is to be redirected.
1108 Policy-based Routing (PBR)