Users Guide

To disable congured timers and return to default mode, use the no ip pim [vrf vrf-name] sparse-
mode sg-expiry-timer command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable expiry
timer for all sources on that VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
seconds Enter the number of seconds the S, G entries are retained. The range is from 211 to
65535.
access-list-name (OPTIONAL) Enter the name of a previously congured Extended ACL to enable the
expiry time to specied S,G entries.
Defaults Disabled. The default expiry timer (with no times congured) is 210 sec.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-Series.
7.7.1.1 Introduced
Usage Information This command congures an expiration timer for all S.G entries, unless they are assigned to an Extended ACL.
Even though the FHR nodes act as RPs, these nodes still send Register encap messages to themselves and
expect to receive a Register stop message (for Anycast RP support). As a result, if the DLT timer expires, SG is not
deleted until the register state is deleted in the node. This register state expires 210 seconds after the last Null
register is received.
ip pim ssm-range
Specify the SSM group range using an access list.
Syntax
ip pim [vrf vrf-name] ssm-range {access_list_name}
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to specify the
SSM group range for that VRF.
1130 PIM-Sparse Mode (PIM-SM)