Users Guide
ip rip send version
To send a specic version of RIP, set the interface. The version you set on the interface overrides the version command in ROUTER RIP
mode.
S3048–ON
Syntax
ip rip send version [1] [2]
To return to the default value, use the no ip rip send version command.
Parameters
1 (OPTIONAL) Enter the number 1 for RIP version 1. The default is RIP version 1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.
Defaults RIPv1
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information To enable the interface to send both version of RIP packets, use the ip rip send version 1 2 command.
Related Commands
• ip rip receive version — sets the RIP version for the interface to receive trac.
• version — sets the RIP version for the switch software.
1242 Routing Information Protocol (RIP)