Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information This command is intended for low-speed interfaces.
passive-interface
Suppress routing updates on a specied interface.
S3048–ON
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
Parameters
interface Enter the following information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a Port Channel interface, enter the keywords port-channel then a number.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes ROUTER RIP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
1248 Routing Information Protocol (RIP)