Users Guide

• xstp — Enable 802.1s, 802.1w, and PVST+ state change traps
The default is all trap types are sent to host.
Defaults As above.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1(0.0) Added support for cong and ecmp traps.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for VRRP traps.
7.6.1.0 Added support for STP and xSTP notication types. Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information
To congure the router to send SNMP notications, enter at least one snmp-server host command. If you
enter the command with no keywords, all trap types are enabled for the host. If you do not enter an snmp-
server host
command, no notications are sent.
In order to enable multiple hosts, issue a separate snmp-server host command for each host. You can specify
multiple notication types in the command for each host.
When multiple snmp-server host commands are given for the same host and type of notication (trap or
inform), each succeeding command overwrites the previous command. Only the last snmp-server host
command will be in eect. For example, if you enter an snmp-server host inform command for a host and
then enter another snmp-server host inform command for the same host, the second command replaces
the rst command.
The snmp-server host command is used with the snmp-server enable command. Use the snmp-
server enable command to specify which SNMP notications are sent globally. For a host to receive most
notications, at least one snmp-server enable command and the snmp-server host command for that
host must be enabled.
1414 Simple Network Management Protocol (SNMP) and Syslog