Users Guide

snmp-server user
Congure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-name udp-port port-
number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv {des56
| aes128} priv password] [access access-list-name | ipv6 access-list-name |
access-list-name ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name remote
ip-address udp-port port-number} [1 | 2c | 3] [encrypted] [auth {md5 | sha}
auth-password] [priv {des56 | aes128} priv password] [access access-list-name |
ipv6 access-list-name | access-list-name ipv6 access-list-name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that connects to
the agent.
group_name Enter a text string (up to 20 characters long) as the name of the group. The following
groups are created for mapping to read/write community/security-names (defaults):
• v1v2creadu — maps to a community with ro permissions.
• 1v2cwriteu — maps to a community rw permissions.
remote ip-address Enter the keywords udp-port then the user datagram protocol (UDP) port number on
the remote device. The range is from 0 to 65535. The default is 162.
vrf vrf-name Enter the keywords vrf and then the name of the VRF this is used to connect to the
SNMP server.
NOTE: Use this attribute to specify a VRF name that is used to connect to the
remote host. If no VRF is specied, then the default VRF is used.
udp-port port-
number
Enter the keywords udp-port then the UDP (User Datagram Protocol) port number on
the remote device. The range is from 0 to 65535. The default is 162.
1 | 2c | 3 (OPTIONAL) Enter the security model version number (1, 2c, or 3):
• 1 is the least secure version.
• 3 is the most secure of the security modes.
• 2c allows transmission of informs and counter 64, which allows for integers twice the
width of what is normally allowed.
The default is 1.
encrypted (OPTIONAL) Enter the keyword encrypted to specify the password appear in
encrypted format (a series of digits, masking the true characters of the string).
auth (OPTIONAL) Enter the keyword auth to specify authentication of a packet without
encryption.
md5 | sha (OPTIONAL) Enter the keyword md5 or sha to designate the authentication level.
• md5 — Message Digest Algorithm
• sha — Secure Hash Algorithm
1418 Simple Network Management Protocol (SNMP) and Syslog