Users Guide

vlan-stack dot1p-mapping
Map C-Tag dot1p values to an S-Tag dot1p value.
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
Parameters
c-tag-dot1p value Enter the keyword c-tag-dot1p then the customer dot1p value that is mapped to a
service provider do1p value. The range is from 0 to 7.
sp-tag-dot1p value Enter the keyword sp-tag-dot1p then the service provider dot1p value. The range is
from 0 to 7.
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the C-Series and S-Series.
Usage Information
You can separate the C-Tag values by commas or dashed ranges. In the case of conicts, dynamic mode CoS
overrides any Layer 2 QoS conguration.
vlan-stack protocol-type
Dene the stackable VLAN tag protocol identier (TPID) for the outer VLAN tag (also called the VMAN tag). If you do not congure this
command, the Dell Networking OS assigns the value 0x9100.
Syntax
vlan-stack protocol-type number
Parameters
number Enter the hexadecimal number as the stackable VLAN tag.
You may specify both bytes of the 2-byte S-Tag TPID. The range is from 0 to FFFF. The
default is 9100.
Defaults 0x9100
1548 VLAN Stacking