Users Guide
Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
disable
Disable a VRRP group.
Syntax
disable
To re-enable a disabled VRRP group, use the no disable command.
Command Modes VRRP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information To enable VRRP trac, assign an IP address to the VRRP group using the virtual-address command and
enter no disable.
Related Commands
• virtual-address — specify the IP address of the virtual router.
hold-time
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization of the VRRP MASTER, the
new switch can stabilize its routing tables.
Syntax
hold-time {seconds | centisecs centisecs}
1598 Virtual Router Redundancy Protocol (VRRP)