Users Guide

implicit-permit (OPTIONAL) Enter the keyword implicit-permit to change the default action of the
ACL from implicit-deny to implicit-permit (that is, if the trac does not match the lters
in the ACL, the trac is permitted instead of dropped).
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the ID numbers of the VLANs. The range is
from 1 to 4094 (you can use IDs from 1 to 4094).
vrf vrf-name (OPTIONAL) Enter the keyword vrf then the ID numbers of the VRFs. The range is from
1 to 63 (you can use IDs from 1 to 63).
NOTE: When you specify a single VRF, use the name of the VRF instead of
the VRF ID number. Use the VRF ID numbers only when you specify a range
of VRFs.
Defaults Not enabled.
Command Modes INTERFACE/VRF MODE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up
to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information You can assign one ingress ACL and one egress ACL to an interface.
NOTE: This command supports Loopback interfaces EE3 and EF series route processor modules
(RPMs). This command does not support Loopback interfaces ED series RPMs and S-Series Loopback
interfaces.
NOTE: If you apply outbound(egress) IP acl on a switch port, the lter applies only for routed trac
egressing out of that port.
To associate an access-list to a non-default VRF, use the vrf attribute of this command. You can use this
command at the interface context (physical/LAG) to apply the access-list to a range of VRFs.
The VRF MODE is not available for the default and management VRFs.
Access Control Lists (ACL) 181