Users Guide

Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information If you enter the clear ip bgp flap-statistics command without any parameters, all statistics are
cleared.
Related Commands
• show debugging — view the enabled debugging operations.
• show ip bgp ap-statistics — view the BGP ap statistics.
• undebug all — disable all debugging operations.
clear ip bgp peer-group
Reset a peer-group’s BGP sessions.
Syntax
clear ip bgp [vrf vrf-name] peer-group peer-group-name [ipv4 [multicast |
unicast] | ipv6 unicast] [soft {in | out}]
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to reset the peer group
corresponding to that VRF.
NOTE: You can use this attribute on a specic VRF to remove history routes
corresponding to that VRF. You can also use this attribute to return the
suppressed routes corresponding to a specic VRF to an active state.
peer-group-name Enter the peer group name to reset the BGP sessions within that peer group.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to reset
ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to reset ipv4
unicast routes.
Border Gateway Protocol 351