Users Guide

When you apply a default route to a BGP peer or peer group using the neighbor default-originate
command, changes to the congured default route-map are applied to the BGP peer or peer group only after a
delay of 15 seconds. As a result, you must wait for a period of 15 seconds before manually resetting BGP using the
clear ip bgp command.
In case of eBGP, the neighbor default-originate command does not support extended-community as a
non-transtive route-map attribute.
You cannot set this conguration for a peer that is associated with a peer group. Similarly, you cannot associate a
peer to a peer group if that peer is already congured with these settings.
In order that settings corresponding to the neighbor default-originate command take eect, you must
execute the clear ip bgp command immediately after you execute the neighbor default-originate
command.
neighbor description
Assign a character string describing the neighbor or group of neighbors (peer group).
Syntax
neighbor {ip-address | peer-group-name} description text
To delete a description, use the no neighbor {ip-address | peer-group-name} description
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
text Enter a continuous text string up to 80 characters.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
368 Border Gateway Protocol