Users Guide

Debugging and Diagnostics
The basic debugging and diagnostic commands are supported by the Dell Networking OS.
Topics:
• Diagnostics and Monitoring Commands
• Oine Diagnostic Commands
• Hardware Commands
Diagnostics and Monitoring Commands
The following section describes the diagnostics and monitoring commands.
For similar commands, refer to the Control and Monitoring chapter.
logging coredump stack-unit
Enable coredump on a stack.
Syntax
logging coredump stack-unit {stack-unit-number | all}
Parameters
stack-unit stack-
unit-number
Enter the stack-unit id to enable coredump in a particular stack-unit.
all Enable coredump on all stack-unit.
Defaults Disabled by default on customer builds.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
12
Debugging and Diagnostics 459