Users Guide
Prompt Interface Type
Dell(conf-if)#
INTERFACE mode
Dell(conf-if-
gi-1/1)#
Gigabit Ethernet interface then the slot/port information
Dell(conf-if-
te-1/1)#
Ten-Gigabit Ethernet interface then slot/port information
Dell(conf-if-
lo-0)#
Loopback interface number
Dell(conf-if-
nu-0)#
Null Interface then zero
Dell(conf-if-
po-0)#
Port-channel interface number The range is from 1 to 128.
Dell(conf-if-
vl-0)#
VLAN Interface then VLAN number (range 1–4094)
Dell(conf-if-
ma-1/1)#
Management Ethernet interface then slot/port information
Dell(conf-if-
tu-0)#
Tunnel interface then tunnel ID.
Dell(conf-if-
range)#
Designated interface range (used for bulk conguration).
IP ACCESS LIST Mode
To enter IP ACCESS LIST mode and congure either standard or extended access control lists (ACLs), use the ip access-list
standard
command or the ip access-list extended command.
To enter IP ACCESS LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter either the ip access-list standard command or the ip access-list extended command. Include a name for
the ACL. The prompt changes to include conf-std-nacl or conf-ext-nacl.
You can return to CONFIGURATION mode by using the exit command.
ISIS ADDRESS-FAMILY Mode
To enable or congure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, see Intermediate System to Intermediate
System (IS-IS).
To enter ISIS ADDRESS-FAMILY mode:
1 Verify that you are logged in to ROUTER ISIS mode.
2 Enter the address-family ipv6 unicast command. The prompt changes to include conf-router_isis-af_ipv6.
LLDP Mode
To enable and congure Link Layer Discovery Protocol (LLDP), use LLDP mode. For more information, see Link Layer Discovery Protocol
(LLDP).
To enter LLDP mode:
50
CLI Basics