Users Guide

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the protocol spanning-tree mstp command. The prompt changes to include conf-mstp.

You can return to CONFIGURATION mode by using the exit command.

OPENFLOW INSTANCE Mode

To enable and congure OpenFlow instances, use OPENFLOW INSTANCE mode.

To enter OPENFLOW INSTANCE mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the openflow of-instance command, and then the OpenFlow ID number of the instance you want to create or congure.

The prompt changes to include conf-of-instance of-id.

You can return to the CONFIGURATION mode by entering the exit command.

Per-VLAN SPANNING TREE (PVST+) Plus Mode

To enable and congure the Per-VLAN Spanning Tree (PVST+) protocol, use PVST+ mode. For more information, see Per-VLAN Spanning

Tree Plus (PVST+).

NOTE

: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.

To enter PVST+ mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the protocol spanning-tree pvst command. The prompt changes to include conf-pvst.

You can return to CONFIGURATION mode by using the exit command.

PORT-CHANNEL FAILOVER-GROUP Mode

To congure shared LAG state tracking, use PORT-CHANNEL FAILOVER-GROUP mode. For more information, see Port Channel

Commands.

To enter PORT-CHANNEL FAILOVER-GROUP mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the port-channel failover-group command. The prompt changes to include conf-po-failover-grp.

You can return to CONFIGURATION mode by using the exit command.

PREFIX-LIST Mode

To congure a prex list, use PREFIX-LIST mode.

To enter PREFIX-LIST mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the ip prefix-list command and the name for the prex list. The prompt changes to include conf-nprefixl.

You can return to CONFIGURATION mode by using the exit command.

CLI Basics