Users Guide

• Topology change Rx and Tx counters
• The number of state change counters
Example (Summary)
Dell# show frrp summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
----------------------------------------------
2 UP Master 2 11-20, 25,27-30
31 UP Transit 31 40-41
50 Down Transit 50 32
Dell#
Example (1)
Dell# show frrp 1
Ring protocol 1 is in Master mode
Ring Protocol Interface:
Primary : GigabitEthernet 1/16 State: Forwarding
Secondary: Port-channel 100 State: Blocking
Control Vlan: 1
Ring protocol Timers: Hello-Interval 50 msec Dead-Interval 150 msec
Ring Master's MAC Address is 00:01:e8:13:a3:19
Topology Change Statistics: Tx:110 Rx:45
Hello Statistics: Tx:13028 Rx:12348
Number of state Changes: 34
Member Vlans: 1000-1009
Dell#
Example (2
Summary)
Dell# show frrp 2 summary
Dell#show frrp 2 summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
-----------------------------------------------
2 Up Master 2 11-20, 25, 27-30
Dell#
Related Commands
• protocol frrp — enter the resilient ring protocol and designate a ring identication.
timer
Set the hello interval or dead interval for the Ring control packets.
Syntax
timer {hello-interval milliseconds}| {dead-interval milliseconds}
To remove the timer, use the no timer {hello-interval [milliseconds]}| {dead-interval
milliseconds} command.
Parameters
hello-interval
milliseconds
Enter the keyword hello-interval then the time, in milliseconds, to set the hello
interval of the control packets. The milliseconds must be entered in increments of 50
millisecond; for example, 50, 100, 150, and so on. If an invalid value is entered, an error
message is generated. The range is from 50 to 2000 ms. Default: 500 ms.
dead-interval
milliseconds
Enter the keyword dead-interval then the time, in milliseconds, to set the dead
interval of the control packets. The range is from 50 to 6000 ms. Default: 1500 ms.
NOTE: The congured dead interval must be at least three times the hello
interval.
Force10 Resilient Ring Protocol (FRRP) 547