Users Guide

Version Description
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced on the E-Series.
Related Commands
• show processes restartable — display processes and tasks congured for restartability.
redundancy auto-failover-limit
Specify an auto-failover limit for RPMs. When a non-recoverable fatal error is detected, an automatic RPM failover occurs. This command
does not aect user-initiated (manual) failovers.
Syntax
redundancy auto-failover-limit [count number [period minutes] | period
minutes]]
To disable the auto-failover limit control, use the no redundancy auto-failover-limit command.
Parameters
count number Enter the number of times the RPMs can automatically failover within the period dened
in the period parameter. The range is from 2 to 10. The default is 3.
period minutes Enter a duration in which to allow a number of automatic failovers (limited to the number
dened in the count parameter). The range is from 5 to 9000 minutes. The default is 60
minutes.
Default
• Count: 3
• Period: 60 minutes
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series
Usage Information
If you disable auto failover, enter the redundancy auto-failover-limit (without any parameters) to set
auto failover to the default parameters (Count 3, Period 60 minutes). To view the redundancy status, use the show
redundancy
command.
High Availability (HA) 563