Users Guide

If the IP SA in the incoming IGMP general query frame is lower than the IP address of the VLAN interface, the switch disables its IGMP
snooping Querier functionality.
If the IP SA of the incoming IGMP general query is higher than the VLAN IP address, the switch continues to work as an IGMP
snooping Querier.
clear ip igmp snooping groups
Clear snooping entries from the group cache table.
Syntax
clear ip igmp snooping groups [group-address interface | interface]
Parameters
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface interface Enter the following keywords and the interface information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a port channel interface, enter the keywords port-channel then a number.
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on S-Series and Z–Series.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results.
debug ip igmp snooping
Enable debugging of IGMP snooping packets on interfaces and groups.
Syntax
debug ip igmp snooping [group address | interface]
• To disable debugging of IGMP snooping, use the no debug ip igmp snooping [group address |
interface] command.
Internet Group Management Protocol (IGMP) 591