Users Guide
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL Switch.
Usage Information
The interface group command will create all the non-existent VLANs specied in the range. On successful
command execution, the CLI switches to the interface group context.
The conguration commands inside the group context will be the similar to that of the existing range command.
Note: For release 9.4(0.0), the group command is supported only for VLANs and physical interfaces.
Example
Dell(conf)# interface group ?
gigabitethernet GigabitEthernet interface IEEE 802.3z
tengigabitethernet TenGigabit Ethernet interface
vlan VLAN keyword
Dell(conf)# interface group vlan 1 - 2 , tengigabitethernet 1/10
Dell(conf-if-group-vl-1-2,gi-1/10)# no shutdown
Dell(conf-if-group-vl-1-2,gi-1/10)# end
Related Commands
• interface range — congure a range of interfaces.
• interface vlan — congures a VLAN.
interface loopback
Congure a Loopback interface.
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number command.
Parameters
number Enter a number as the interface number. The range is from 0 to 16383.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Interfaces 613