Users Guide
Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version 6.2.1.0 Introduced on the E-Series.
Usage Information
Use the interface port-channel command to access this command.
You cannot add an interface to a Port Channel if the interface contains an IP address in its conguration. Only the
shutdown, description, mtu, and ip mtu commands can be congured on an interface if it is added to a
Port Channel. The
mtu and ip mtu commands are only available when the chassis is in Jumbo mode.
Link MTU and IP MTU considerations for Port Channels are:
• All members must have the same link MTU value and the same IP MTU value.
• The Port Channel link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values
congured on the channel members. For example, if the members have a link MTU of 2100 and an IP MTU
2000, the Port Channel’s MTU values cannot be higher than 2100 for link MTU or 2000 bytes for IP MTU.
When an interface is removed from a Port Channel with the no channel-member command, the interface
reverts to its conguration prior to joining the Port Channel.
An interface can belong to only one Port Channel.
You can have 16 interfaces per Port Channel. The interfaces can be located on dierent line cards but must be the
same physical type and speed (for example, all 10-Gigabit Ethernet interfaces).
For more information about Port Channels, refer to the Dell Networking OS Conguration Guide.
Related Commands
• description — assign a descriptive text string to the interface.
• interface port-channel — create a Port Channel interface.
• shutdown — disable/enable the port channel.
666 Interfaces