Users Guide

Defaults 240 minutes (4 hours)
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Related Commands
• show interfaces — display the ARP timeout value for all available interfaces.
clear arp-cache
Clear the dynamic ARP entries from a specic interface or optionally delete (no-refresh) ARP entries from the content addressable
memory (CAM).
Syntax
clear arp-cache [vrf vrf-name | interface | ip ip-address] [no-refresh]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to clear the ARP
cache corresponding to that VRF.
interface (OPTIONAL) Enter the following keywords and the interface information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
IPv4 Routing 695