Users Guide
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Added support for VRF.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added support for up to seven stack members.
7.6.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip cam command shown in the following example.
Field Description
Destination Displays the destination route of the index.
EC Displays 1 if the route is an ECMP route. Else, displays 0.
C This is the CPU bit. If it displays 1, then it indicates that a packet hitting this entry will be
forwarded to the CPU.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface.
• CP = control processor
• Gi = Gigabit Ethernet interface
• Te = 10–Gigabit Ethernet interface
Example
Dell# show ip cam stack-unit 3 po 0 1.1.1.0/24 longer-prefixes
Destination EC C VId Mac-Addr Port
---------------------------------------------------------------
1.1.1.2/32 0 0 3000 00:05:00:00:00:02 Gi 3/44
1.1.1.1/32 0 1 0 00:00:00:00:00:00 CP
1.1.1.0/24 0 1 0 00:00:00:00:00:00 CP
Dell#
Example (ECMP-
Group)
Dell# show ip cam stack-unit 3 po 0 ecmp-group detail
Destination EC C VId Mac-Addr Port ECMP Group-Index
-----------------------------------------------------------------------
1.1.1.2/32 0 0 1000 00:01:00:00:00:02 Gi 3/42 -
2.1.1.2/32 0 0 20 00:03:00:00:00:02 Po 10 -
2.1.1.1/32 0 1 0 00:00:00:00:00:00 CP -
1.1.1.1/32 0 1 0 00:00:00:00:00:00 CP -
2.1.1.0/24 0 1 0 00:00:00:00:00:00 CP -
1.1.1.0/24 0 1 0 00:00:00:00:00:00 CP -
100.1.1.0/24 1 0 20 00:03:00:00:00:02 Po 10 0
IPv4 Routing 735