Users Guide

Parameters
vrf vrf–name (Optional) Enter the keyword vrf followed by the name of the VRF to clear the neighbor
corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the
default VRF are cleared.
slot Enter the slot number to clear the FIB.
unit-number Enter the stack member number. The range is from 1to 6
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
clear ipv6 route
Clear (refresh) all or a specic route from the IPv6 routing table.
Syntax
clear ipv6 route [vrf vrf-name] {* | ipv6-address prefix-length}
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to clear the IPv6
routes corresponding to that VRF.
* Enter the * to clear (refresh) all routes from the IPv6 routing table.
ipv6-address prex-
length
Enter the IPv6 address in the x:x:x:x::x format then the prex length in the /x format. The
range is from /0 to /128.
NOTE: The :: notation species successive hexadecimal elds of zeros.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
766 IPv6 Basics