Users Guide

Version Description
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
For the new settings to take eect, save the new CAM settings to the startup-cong (write-mem or copy run
start) then reload the system.
The total amount of space allowed is 16 FP Blocks. System ow requires three blocks and these blocks cannot be
reallocated. The ipv4acl prole range is from 1 to 4.
When conguring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM proles are from 1 to 10, except for the ipv6acl prole which is from 0 to 10. The ipv6acl
allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP, to perform a reload on the chassis to upgrade any conguration changes that have changed
the NVRAM content, use the reload conditional nvram-cfg-change command.
cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
Syntax
cam-acl-vlan {default | vlanopenflow {0|1}}
Defaults Disabled.
Parameters
default Reset VLAN CAM ACL entries to default settings
vlanopenow Enter the number 1 to allocate VFP blocks and enable OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.1.(0.0) Introduced on S4810.
8.3.19.0 Introduced on the S4820T.
Usage Information
Reboot the switch after changing the parameter values for changes to take eect.
For platform-specic instructions about using this command, see the SDN section of the Dell Networking OS
Conguration Guide.
88 Control and Monitoring