Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

881

882

883

884

885

886

887

888

889

890

disabled” state, you must enter the fefd reset command to reset the interface

state. Range is normal or aggressive. Default is normal.

Defaults Disabled.

Command Modes INTERFACE

Command History

This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.12.0 Introduced on the S4810.

Usage Information When you enter no fefd for an interface and fefd-global, FEFD is enabled on the interface because the no

fefd command is not retained in the conguration le. To keep the interface FEFD disabled when the global

conguration changes, use the

fefd reset command.

Related Commands

• fefd disable — disable far-end failure detection on an interface.

• fefd reset — enable FEFD globally on the system.

• fefd mode — change FEFD mode on an interface.

fefd disable

Disable FEFD on an interface only. This command overrides the fefd reset command for the interface.

Syntax