Users Guide
hello
Congure the rate at which the LLDP control packets are sent to its peer.
Syntax
hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds Enter the rate, in seconds, at which the control packets are sent to its peer. The rate is
from 5 to 180 seconds. The default is 30 seconds.
Defaults 30 seconds
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
management-interface
Enable and congure LLDP protocol parameters on the management interface.
Syntax
management-interface
To remove LLDP conguration on a management interface, use the no management-interface command.
904 Link Layer Discovery Protocol (LLDP)