Users Guide
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information The following commands are not supported by the do command:
• enable
• disable
• exit
• config
Example
Dell(conf-if-gi-5/1)#do clear counters
Clear counters on all interfaces [confirm]
Dell(conf-if-gi-5/1)#
Dell(conf-if-gi-5/1)#do clear logging
Clear logging buffer [confirm]
Dell(conf-if-gi-5/1)#
Dell(conf-if-gi-5/1)# do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
Dell(conf-if-gi-5/1)#
enable
Enter EXEC Privilege mode or any other privilege level congured. After entering this command, you may need to enter a password.
Syntax
enable [level]
Parameters
level (OPTIONAL) Enter a number for a privilege level of Dell Networking OS. The range is
from 0 to 15.
Defaults 15
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
92 Control and Monitoring