Administrator Guide
NOTE: BGP and ISIS routes are not available on the C-Series. BGP, ISIS, and
RIP routes are not available on the S-Series.
static (OPTIONAL) Enter the keyword static to specify that only manually congured routes
are distributed.
Defaults Not congured.
Command Modes ROUTER OSPF
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for the Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information The distribute-list out command applies to routes autonomous system boundary routers (ASBRs)
redistributes into OSPF. It can be applied to external type 2 and external type 1 routes, but not to intra-area and
inter-area routes.
fast-convergence
This command sets the minimum LSA origination and arrival times to zero (0), allowing more rapid route computation so that convergence
takes less time.
S3048–ON
Syntax
fast-convergence {number}
To cancel fast-convergence, use the no fast convergence command.
Parameters
number Enter the convergence level desired. The higher this parameter is set, the faster OSPF
converge takes place. The range is from 1 to 4.
Open Shortest Path First (OSPFv2 and OSPFv3) 1085