Administrator Guide
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.
8.3.19.0 Introduced on the S4820T.
7.8.1.0 Added support for the C-Series.
7.4.1.0 Introduced on the E-Series.
Example
Dell# show ipv6 ospf 3 neighbor gi 1/2
Neighbor ID Pri State Dead Time Interface ID Interface
63.114.8.36 1 FULL/DR 00:00:38 4 Gi 1/2
Dell#
timers spf
Set the time interval between when the switch receives a topology change and starts a shortest path rst (SPF) calculation.
S3048–ON
Syntax
timers spf delay holdtime msec
To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is from 0 to 2147483647. The default is 5
seconds. When congured in milli seconds, 100 is the least value that is allowed to be
congured.
holdtime Enter a number as the hold time. The range is from 0 to 2147483647. The default is 10
seconds. When congured in milli seconds, 200 is the least value that is allowed to be
congured.
msec Enter the keyword msec to specify the time interval value in milli seconds.
NOTE: If you do not specify the msec option, the timer values are considered
as seconds.
Defaults
• delay = 5 seconds
• holdtime = 10 seconds
Command Modes ROUTER OSPFv3 for OSPFv3 and ROUTER OSPFv2 for OSPFv2
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Open Shortest Path First (OSPFv2 and OSPFv3) 1181