Administrator Guide
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Introduced GRE protocol support.
monitor multicast-queue
Congure monitor QoS multicast queue ID.
Syntax
monitor multicast-queue queue-id
To remove the conguration, use the no monitor multicast-queue command.
Parameters
queue-id Enter the QoS multicast queue ID. The range is from 0 to 9.
Defaults
queue-id: 0
Enable status: Disabled
Command Modes CONFIGURATION
Example
Dell(conf)#monitor multicast-queue 7
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Introduced on the S6000, Z9500, S6000-ON.
Related Commands show running-cong monitor session — displays information about monitor congurations.
monitor session
Create a session for monitoring trac with port monitoring.
Syntax
monitor session session-ID [type { rpm | erpm [set ip dscp dscp_value | set ip
ttl ttl_value]}] [drop]
To delete a session, use the no monitor session session-ID command.
Port Monitoring 1227