Administrator Guide

Parameters
description Enter a description to identify the policies (80 characters maximum).
Defaults none
Command Modes CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in and conf-qos-policy-out; wred)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
pre- 7.7.1.0 Introduced.
Related Commands
• policy-map-input — creates an input policy map.
• policy-map-output — creates an output policy map.
• qos-policy-input — creates an input QoS-policy on the router.
• qos-policy-output — creates an output QoS-policy on the router.
• wred-prole — creates a WRED prole.
match ip access-group
Congure match criteria for a class map, based on the access control list (ACL).
NOTE
: IPv6 class-maps and IP-any class-maps do not match. This condition is true for IPv6 and IP-any class-maps on both ACLs
as well as VLANs.
Syntax
[seq sequence number] match ip access-group access-group-name [set-ip-dscp
value | set-color value]
To remove ACL match criteria from a class map, use the no [seq sequence number] match ip
access-group access-group-name [set-ip-dscp value | set-color value] command.
Parameters
seq sequence
number
(OPTIONAL) Enter the keyword seq then the sequence number. The range is from 1 to
100. By default, the sequence number are assigned in multiples of ve.
access-group-name Enter the ACL name whose contents are used as the match criteria in determining if
packets belong to the class the class-map species.
1268 Quality of Service (QoS)