Administrator Guide
Parameters
delay Specify a number of milliseconds as the delay interval. The range is from 8 to 50.
Defaults Not congured.
Command Modes ROUTER RIP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information This command is intended for low-speed interfaces.
passive-interface
Suppress routing updates on a specied interface.
S3048–ON
Syntax
passive-interface interface
To delete a passive interface, use the no passive-interface interface command.
Parameters
interface Enter the following information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a Port Channel interface, enter the keywords port-channel then a number.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Routing Information Protocol (RIP) 1331