Administrator Guide

NOTE: Use this attribute to specify the VRF that is used by the SNMP engine
to reach the device. If no VRF is specied, then the default VRF is used.
udp-port port-
number engineID
Enter the keywords udp-port followed by the user datagram protocol (UDP) port
number on the remote device. The range is from 0 to 65535. The default is 162.
Defaults As above.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information
Changing the value of the SNMP Engine ID has important side eects. A user’s password (entered on the
command line) is converted to a message digest algorithm (MD5) or secure hash algorithm (SHA) security digest.
This digest is based on both the password and the local Engine ID. The command line password is then destroyed,
as required by RFC 2274. Because of this deletion, if the local value of the Engine ID changes, the security digests
of SNMPv3 users is invalid and the users will have to be recongured.
For the remote Engine ID, the host IP and UDP port are the indexes to the command that are matched to either
overwrite or remove the conguration.
Related Commands
• show snmp engineID — displays the SNMP engine and all the remote engines that are congured on the
router.
• show running-cong snmp — displays the SNMP running conguration.
1502 Simple Network Management Protocol (SNMP) and Syslog