Administrator Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and added support for IPv6 address on the E-Series only.
Usage Information
The VRF congured using this command has a higher precedence than a VRF congured using the ip telnet
vrf vrf-name command. If you do not use the VRF attribute in this command, then TELENT client uses the
VRF congured using the
ip telnet vrf vrf-name command.
The source interface congured using this command has a higher precedence than the source interface congured
using the ip telnet source-interface command. If you do not congure a source interface using this
command, then the TELNET client uses the source interface congured using the
ip telnet source-
interface command.
In case there is a mismatch between the VRF telnet source interface and the telnent VRF, then an error is
reported.
Example
Dell# telnet vrf vrf1 10.10.10.2
telnet-peer-stack-unit
Open a Telnet connection to the peer stack unit.
Syntax
telnet-peer-stack-unit
Defaults Not congured.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S-Series.
Control and Monitoring 151