Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related Commands
• logging trap — limit messages logged to the Syslog servers based on severity.
logging
Congure an IP address or host name of a Syslog server where logging messages are sent. Multiple logging servers of both IPv4 and/or
IPv6 can be congured.
Syntax
logging {ip-address | ipv6-address | hostname} {{udp {port}} | {tcp {port}}
[vrf vrf-name]
To disable logging, use the no logging command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation species successive hexadecimal elds of zeros.
hostname Enter the name of a host already congured and recognized by the switch.
udp Enter the keyword udp to enable transmission of log message over UDP followed by port
number. The default port is 514
tcp Enter the keyword tcp to enable transmission of log message over TCP followed by port
number.
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the VRF to enable the logging
process in VRF mode.
NOTE: Use this attribute to specify the VRF that is used to contact the host.
By default, the default VRF is used.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Simple Network Management Protocol (SNMP) and Syslog 1521