Administrator Guide

Parameters
all Enter the keyword all to ensure that all levels are printed asynchronously.
level level Enter the keyword level then a number as the severity level. A high number indicates a
low severity level and vice versa. The range is from 0 to 7. The default is 2.
all Enter the keyword all to turn o all.
limit number-of-
buers
Enter the keyword limit then the number of buers to be queued for the terminal after
which new messages are dropped. The range is from 20 to 300. The default is 20.
Defaults Disabled. If enabled without the level or number-of-buffers options specied, level = 2 and number-of-
buers = 20 are the defaults.
Command Modes LINE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information
When you enable logging synchronous, unsolicited messages appear between software prompts and
outputs. Only the messages with a severity at or below the set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a system message appears on
that terminal line. Messages may continue to appear on other terminal lines.
Related Commands
• logging on — enables logging.
1532 Simple Network Management Protocol (SNMP) and Syslog