Administrator Guide

• show system – displays the current status of all stack members or a specic member.
stack-unit priority
Congure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-number priority priority-value
Parameters
stack-number Enter the stack member unit identier.
priority-value This preference parameter allows you to specify the management priority of one backup
switch over another, with 1 as the lowest priority and 14 being the highest. The switch
with the highest priority value is chosen to become the management unit if the active
management unit fails or on the next reload.
Defaults 1
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Related Commands
• reload – reboots Dell Networking OS.
stack-unit provision
Precongure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the management unit.
Syntax
stack-unit [stack-number] provision {model-identifier}
Parameters
stack-number Enter a stack member identier of the switch that you want to add to the stack.
model-identier Enter the model identier of the switch to be added as a stack member. This identier is
also referred to as the provision type.
Defaults When this value is not set, a switch joining the stack is given the next available sequential stack member identier.
Command Modes CONFIGURATION
Stacking 1563