Administrator Guide

storm-control broadcast (Conguration)
Congure the percentage of broadcast trac allowed in the network.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast rate-limiting, use the no storm-control broadcast [packets_per_second in]
command.
storm-control broadcast [percentage decimal_value in | out]| [wred-profile name]]
[packets_per_second in]
To disable broadcast rate-limiting, use the storm-control broadcast [percentage decimal_value in | out] | [wred-
prole name]] [packets_per_second in] command.
Parameters
percentagedecimal
_value in | out
Enter the percentage of broadcast trac allowed in or out of the network. Optionally, you
can designate a decimal value percentage, for example, 55.5%. The decimal range is
from .1 to .9.
wred-prole name Enter the keyword wred-prole followed by the prole name to designate a wred-prole.
packets_per_secon
d in
Enter the packets per second of broadcast trac allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-MUX
(PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Added the percentage decimal value option.
6.5.1.0 Introduced on the E-Series.
Storm Control 1571