Administrator Guide

Related Commands
• disable — disables spanning tree group 0. To enable spanning tree group 0, use the no disable command.
show cong
Display the current conguration for the mode. Only non-default values display.
Syntax
show config
Command Modes SPANNING TREE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(config-stp)# show config
protocol spanning-tree 0
no disable
Dell(config-stp)#
show spanning-tree 0
Display the spanning tree group conguration and status of interfaces in the spanning tree group.
Syntax
show spanning-tree 0 [active | brief | guard | interface interface | root |
summary]
Parameters
0 Enter 0 (zero) to display information about that specic spanning tree group.
active (OPTIONAL) Enter the keyword active to display only active interfaces in spanning tree
group 0.
Spanning Tree Protocol (STP) 1585