Administrator Guide
Tunneling
Tunneling is supported on Dell Networking OS.
Topics:
• ip unnumbered
• ipv6 unnumbered
• tunnel allow-remote
• tunnel destination
• tunnel dscp
• tunnel ow-label
• tunnel hop-limit
• tunnel keepalive
• tunnel-mode
• tunnel source
ip unnumbered
Congure a tunnel interface to operate without a unique IPv4 address and select the interface from which the tunnel borrows its address.
Syntax
ip unnumbered interface-type
To set the tunnel back to default logical address use the no ip unnumbered command. If the tunnel was
previously operational, the tunnel interface is operationally down unless you also congure the tunnel IPv6 address.
Parameters
interface-type
Enter the interface type, followed by a slot/port/subport number.
Defaults None
Command Modes INTERFACE TUNNEL
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
57
1630 Tunneling