Administrator Guide

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.2.3 Introduced on the S-Series S50.
Related Commands
• clear ufd-disable — re-enable downstream interfaces that are in a UFD-Disabled Error state.
description
Enter a text description of an uplink-state group.
Syntax
description text
Parameters
text Text description of the uplink-state group. The maximum length is 80 alphanumeric
characters.
Defaults none
Command Modes UPLINK-STATE-GROUP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10.0.2 Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.2.3 Introduced on the S-Series S50.
Example
Dell(conf-uplink-state-group-16)# description test
Dell(conf-uplink-state-group-16)#
Related Commands
• uplink-state-group — create an uplink-state group and enables the tracking of upstream links.
downstream
Assign a port or port-channel to the uplink-state group as a downstream interface.
Syntax
downstream interface
Uplink Failure Detection (UFD) 1641