Administrator Guide

• eq(equal to) — matches packets that contain a ttl value that is equal to the specied
ttl value.
• neq(not equal to) — matches packets that contain a ttl value that is not equal to the
specied ttl value.
• gt(greater than) — matches packets that contain a ttl value that is greater than the
specied ttl value.
•
lt (less than) — matches packets that contain a ttl value that is less than the
specied ttl value.
• range(inclusive range of values) — matches packets that contain a ttl value that
falls between the specied range of ttl values.
count (OPTIONAL) Enter the keyword count to count packets processed by the lter.
bytes (OPTIONAL) Enter the keyword bytes to count bytes processed by the lter.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-
order numbers have a higher priority). If you do not use the keyword order, the ACLs
have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
monitor (OPTIONAL) Enter the keyword monitor to describe the trac that you want to
monitor and the ACL in which you are creating the rule is applied to the monitored
interface. For more information, see “Flow-based Monitoring” in the Port Monitoring
section of the Dell Networking OS Conguration Guide.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not congured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the ttl parameter. Removed the session–ID option from the monitor
parameter.
9.11(0.0) Added support for session–ID to the monitor parameter.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
212 Access Control Lists (ACL)