Administrator Guide

set weight
To add a non-RFC compliant attribute to the BGP route to assist with route selection, congure a lter.
Syntax
set weight weight
To delete a weight specication, use the no set weight weight command.
Parameters
weight Enter a number as the weight used by the route meeting the route map specication. The
range is from 0 to 65535. The default is router-originated = 32768 and all other routes =
0.
When there are multiple routes to the same destination, the routes with a higher weight
are preferred.
Defaults router-originated = 32768; all other routes = 0
Defaults Not congured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information If you do not use the set weight command, router-originated paths have a weight attribute of 32768 and all
other paths have a weight attribute of zero.
268 Access Control Lists (ACL)