Administrator Guide

• Use the no deny udp {source mask | any | host ip-address} {destination mask |
any | host ip-address} command.
Parameters
ttl Enter the keyword ttl to deny a packet based on the time to live value. The range is
from 1 to 255.
operator Enter one of the following logical operand:
• eq(equal to) — matches packets that contain a ttl value that is equal to the specied
ttl value.
• neq(not equal to) — matches packets that contain a ttl value that is not equal to the
specied ttl value.
•
gt(greater than) — matches packets that contain a ttl value that is greater than the
specied ttl value.
• lt (less than) — matches packets that contain a ttl value that is less than the
specied ttl value.
• range(inclusive range of values) — matches packets that contain a ttl value that
falls between the specied range of ttl values.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated. with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The time interval range is from 1 to 10 minutes.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is ve minutes.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the ttl parameter.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.3(0.0) Added support for logging of ACLs on the S4810, S4820T, and Z9000 platforms.
Usage Information
When the congured maximum threshold is exceeded, generation of logs is stopped. When the interval at which
ACL logs are congured to be recorded expires, the subsequent, fresh interval timer is started and the packet
count for that new interval commences from zero. If ACL logging was stopped previously because the congured
threshold is exceeded, it is re-enabled for this new interval.
If ACL logging is stopped because the congured threshold is exceeded, it is re-enabled after the logging interval
period elapses. ACL logging is supported for standard and extended IPv4 ACLs, IPv6 ACLs, and MAC ACLs. You
280 Access Control Lists (ACL)