Administrator Guide

can congure ACL logging only on ACLs that are applied to ingress interfaces; you cannot enable logging for ACLs
that are associated with egress interfaces.
Related Commands
• deny — assign a lter to deny IP trac.
• deny tcp — assign a lter to deny TCP trac.
deny arp (for Extended MAC ACLs)
Congure an egress lter that drops ARP packets on egress ACL supported line cards. (For more information, refer to your line card
documentation).
Syntax
deny arp {destination-mac-address mac-address-mask | any} vlan vlan-id {ip-
address | any | opcode code-number} [count [byte]] [order] [log [interval
minutes] [threshold-in-msgs [count]] [monitor]
To remove this lter, you have two choices:
• Use the no seq sequence-number command if you know the lter’s sequence number.
•
Use the no deny arp {destination-mac-address mac-address-mask | any} vlan vlan-
id {ip-address | any | opcode code-number} command.
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The time interval range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the trac that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is ve minutes. By default, ow-based monitoring is not
enabled.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4(0.0) Added support for ow-based monitoring on the S4810, S4820T, S6000, and Z9000
platforms.
Access Control Lists (ACL) 281