Administrator Guide

host ip-v6address Enter the keyword host then the IPv6 address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
ttl Enter the keyword ttl to permit a packet based on the time to live value. The range is
from 1 to 255.
operator Enter one of the following logical operand:
• eq(equal to) — matches packets that contain a ttl value that is equal to the specied
ttl value.
• neq(not equal to) — matches packets that contain a ttl value that is not equal to the
specied ttl value.
•
gt(greater than) — matches packets that contain a ttl value that is greater than the
specied ttl value.
• lt (less than) — matches packets that contain a ttl value that is less than the
specied ttl value.
• range(inclusive range of values) — matches packets that contain a ttl value that
falls between the specied range of ttl values.
count (OPTIONAL) Enter the keyword count to count packets processed by the lter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the lter.
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated with the seq, permit, or deny commands. The threshold
range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. The interval range is from 1 to 10 minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the trac that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is ve minutes. By default, ow-based monitoring is not
enabled.
Command Modes ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the ttl parameter.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.5(0.1) Introduced on the Z9500.
312 Access Control Lists (ACL)