Administrator Guide

map-name
Enter the name of an established route map.
If the Route map is not congured, the default is deny (to drop all routes).
in Enter the keyword in to lter inbound routes.
out Enter the keyword out to lter outbound routes.
NOTE: This command sends routes to peers only if an outbound policy is
congured and if there is a change in the existing outbound policy.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
When you apply a route map to outbound routes, only routes that match at least one section of the route map are
permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route map used
in this command. If you identify a peer by IP address, the Route map overwrites either the inbound or outbound
policies on that peer.
neighbor route-reector-client
Congure the router as a route reector and the specied neighbors as members of the cluster.
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To remove one or more neighbors from a cluster, use the no neighbor {ip-address | peer-group-
name} route-reflector-client command. If you delete all members of a cluster, you also delete the
route-reector conguration on the router.
406 Border Gateway Protocol