Administrator Guide
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route reector.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
A route reector reects routes to the neighbors assigned to the cluster. Neighbors in the cluster do not need not
to be fully meshed. By default, when you use no route reflector, the internal BGP (IBGP) speakers in the
network must be fully meshed.
The rst time you enter this command, the router congures as a route reector and the specied BGP neighbors
congure as clients in the route-reector cluster.
When you remove all clients of a route reector using the no neighbor route-reflector-client
command, the router no longer functions as a route reector.
If the clients of a route reector are fully meshed, you can congure the route reector to not reect routes to
specied clients by using the no bgp client-to-client reflection command.
This command automatically restarts the neighbor session for the conguration to take eect.
Related Commands
• bgp client-to-client reection — enable route reection between the route reector and the clients.
Border Gateway Protocol 407