Administrator Guide

• fedgovacl : 0
l2acl number Enter the keyword l2acl and then the number of l2acl blocks. The range is from 1 to 8.
ipv4acl number Enter the keyword ipv4acl and then the number of FP blocks for IPv4. The range is
from 0 to 8.
ipv6acl number Enter the keyword ipv6acl and then the number of FP blocks for IPv6. The range is
from 0 to 4.
ipv4qos number Enter the keyword ipv4qos and then the number of FP blocks for IPv4. The range is
from 0 to 8.
l2qos number Enter the keyword l2qos and then the number of FP blocks for l2 qos. The range is from
1 to 8.
l2pt number Enter the keyword l2pt and then the number of FP blocks for l2 protocol tunnelling. The
range is from 0 to 1.
Ipmacacl number Enter the keyword ipmacacl and then the number of FP blocks for IP and MAC ACL.
The range is from 0 to 6.
ecfmaclnumber Enter the keyword ecfmacacl and then the number of FP blocks for ECFM ACL. The
range is from 0 to 5.
nlbclusteracl
number
Enter the keyword nlbclusteracl and then the number of FP blocks for nlbcluster
ACL. The range is from 0 to 2. By default, the value is 0 and it supports 8 NLB arp entries
reserved for internal functionality.
NOTE: When you recongure CAM allocation, use the nlbclusteracl
number command to change the number of NLB ARP entries. The range is
from 0 to 2.
The default value is 0. At the default value of 0, eight NLB ARP
entries are available for use. This platform supports up to 512 CAM entries.
Select 1 to congure 256 entries. Select 2 to congure 512 entries. Even
though you can perform CAM carving to allocate the maximum number of
NLB entries, Dell Networking recommends that you use a maximum of 64 NLB
ARP entries.
vman-qos Enter the keyword vman-qos and then the number of FP blocks for VMAN QoS. The
range is from 0 to 6.
vman-dual-qos
number
Enter the keyword vman-dual-qos and then the number of FP blocks for VMAN dual
QoS. The range is from 0 to 4.
Ipv4pbr number Enter the keyword ipv4pbr and then the number of FP blocks for ipv4pbr ACL. The
range is from 0 to 8.
Openow number Enter the keyword openflow and then the number of FP blocks for open ow (multiples
of 4). The range is from 0 to 8.
fcoeacl number Enter the keyword fcoeacl and then the number of FP blocks for FCOE ACL. The
range is from 0 to 6.
Iscsioptacl number Enter the keyword iscsioptacl and then the number of FP blocks for iSCSI
optimization ACL. The range is from 0 to 2.
l2acl number
ipv4acl number
ipv6acl number,
ipv4qos number
l2qos numberl2pt
Allocate space to each CAM region.
Enter 4 or 8 for the number of OpenFlow FP blocks.
• 4: Creates 242 entries for use by the OpenFlow controller (256 total entries minus the
14 entries reserved for internal functionality)
Content Addressable Memory (CAM) 473