Administrator Guide
To disable the ipv6 dhcp snooping on VLAN basis or range of VLAN, use the no ipv6 dhcp snooping vlan
<vlan-id> command.
Parameters
vlan-id Enter the name of a VLAN id or list of the VLANs to enable DHCP Snooping.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S4810, S4820T, S6000, S6000-ON, and Z-Series.
ip dhcp snooping binding
Create a static entry in the DHCP binding table.
Syntax
[no] ip dhcp snooping binding mac address vlan-id vlan-id ip ip-address
interface interface-type lease number
Parameters
mac address Enter the keyword mac then the MAC address of the host to which the server is leasing
the IP address.
vlan-id vlan-id Enter the keywords vlan-id then the VLAN to which the host belongs. The range is
from 2 to 4094.
ip ip-address Enter the keyword ip then the IP address that the server is leasing.
interface type Enter the keyword interface then the type of interface to which the host is
connected:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
lease time Enter the keyword lease then the amount of time the IP address are leased. The range
is from 1 to 4294967295.
Defaults None
Command Modes
• EXEC
536 Dynamic Host Conguration Protocol (DHCP)