Administrator Guide
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface interface Enter the following keywords and the interface information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a port channel interface, enter the keywords port-channel then a number.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results. This command
displays packets for IGMP and IGMP snooping.
ip igmp access-group
To specify access control for packets, use this feature.
Syntax
ip igmp access-group access-list
612 Internet Group Management Protocol (IGMP)